Connecting to Power
The procedure below describes how to connect the device to the AC power supply. You can install up to two Power Supply modules (Power 1 and Power 2) for power redundancy. For installing the Power Supply modules in the chassis, see Power Supply Module.
|
●
|
Units must be connected (by service personnel) to a socket-outlet with a protective earthing connection. |
|
●
|
Use only the AC power cord supplied with the device. |
|
●
|
When using only one Power Supply module, the second AC power socket on the rear panel is covered by a plastic sticker. Please do not remove the sticker and connect anything to this power socket. Remove the sticker only when two Power Supply modules are used. |
(French) Avertissements:
|
●
|
L’appareil doit être branché à une prise murale à condition qu’elle soit mise à la masse. |
|
●
|
Utilisez uniquement le cordon AC fourni avec l’appareil. |
(Japanese) ご注意
本製品に添付の電源ケーブルは、Mediant 1000B Gateway and E-SBC に専用設計されているため、汎用性がありません. 本電源ケーブルを他の機器に使用されないよう、ご注意ください.
For dual power supply:
|
●
|
Connect each Power Supply module to a different AC supply circuit. |
|
●
|
The two AC power sources must have the same ground potential. |
|
●
|
Configure the device to send an SNMP alarm (acPowerSupplyAlarm) upon a failure or removal of any of the installed Power Supply modules. For enabling this functionality, use the [Mediant1000DualPowerSupplySupported] parameter. For more information, refer to the User's Manual. |
|
➢
|
To connect the device to the power supply: |
|
■
|
On the device's rear panel, connect the left (active) 100-240V~50-60 Hz power socket to a standard electrical outlet using the supplied AC power cord. |
Connecting to AC Power Supply
When the device receives powers, the POWER LED on the front panel of the Power Supply module is lit green. If the LED is off, a power supply problem may be present.